Porcelanosa SYSTEM-POOL Manual De Instalación página 8

QUADRI
Shower sets
5. Position the column and mark its top and bottom positions (fig. 4). Remove the column and measure the lenghts
indicated in figure 5. This will serve to mark the positions of the corresponding fixture holes (fig. 3).
6. Drill the holes and insert the hex-cap screws supplied with the kit into the holes (fig. 3).
u r e
fi x t
a
e
h o l
s . A
P o
ASSEMBLING THE COLUMN:
7. Install the column as indicated in zoom 1 and tighten the
screws until snug.
8. Level the column and mark the positions indicated in zoom 2.
9. Remove the column and make the upper drill holes (zoom 2).
10. Connect the hoses supplied with the kit to the water
connection points.
11. Replace the column and screw the top part into position.
NB: Tighten the hex-cap screws so that the column is securely
attached to the wall but can be removed for maintenance
purposes.
7
7
fi x t
u r e
a
h o l
e
P o
s . A
nº 8
x 2
L = 40
Fig.3
fi xture hole
x
fi xture hole
x
a
Fig.4
ZOOM 2
nº8
nº8
x 2
L = 40
ZOOM 1
Installation Manual
x
Fig.5