Installation - Master TENTEvent125 Serie Manual De Instrucciones

WARNING: Review and un-
derstand the warnings in the
Safety section, page 2. They are
needed to safely operate this
heater. Follow all local codes or
in the absence of local codes,
with the Standard for Grand-
stands, Folding and Telescopic
Seating, Tents and Membrane
Structures NFPA 102 and the
Standard for Storage and Han-
dling of Liquiefied Petroleum
Gases ANSI/NFPA 58.
WARNING: Test all gas piping
and connections for leaks after
installation or servicing. Never
use an open flame to check for a
leak. Apply a noncorrosive leak
detection fluid to all joints (avail-
able at local plumbing supply
stores). bubbles forming show a
leak. Correct all leaks at once.
1.. Provide. propane. supply. system. (see.
Propane Supply,.page.6).
Inlet.
Connector
10

inSTaLLaTion

Figure 8 - Hose and Inlet Connector
www.desatech.com
2.. Connect. fuel. gas. connector. fitting. on.
hose/regulator. assembly. to. propane.
tank(s).(see.Figure.7)..Turn.counterclock-
wise.into.threads.on.tank.valve..Tighten.
firmly using wrench.
. IMPORTANT:.Tighten.regulator.with.vent.
pointing. down.. Pointing. vent. down. pro-
tects.regulator.from.weather.damage.
3.. Connect. hose. to. inlet. connector. (see.
Figure 8). Tighten firmly using a wrench.
. IMPORTANT: Extra hose or piping may be
used.if.needed..Install.extra.hose.or.piping.
between. hose/regulator. assembly. and.
propane.tank..You.must.use.the.regulator.
supplied.with.heater.
4.. Open.propane.supply.valve.on.propane.
tank(s).slowly.
. Note: If not opened slowly, excess flow
check valve on propane tank will stop gas
flow. If this happens, close propane supply
valve and open again slowly.
5.. Check.all.connections.for.leaks..Correct.
all.leaks.
Regulator
Supply.Valve
Propane.
Tank
Figure 7 - Regulator With Vent Pointing
Hose
Vent.
(pointing.
down)
Fuel.Gas.
Connector
Down
Hose
120193-01A