Master TENTEvent125 Serie Manual De Instrucciones página 9

Wheels and Axle
1.. Locate. wheels. and. axle. in. packaging..
Remove. 2. push. caps. from. hardware.
packet.
2.. Stand.axle.upright.placing.one.end.on.the.
floor. Gently tap one push cap onto end
of.axle.
3.. Slide.one.wheel.onto.axle.then.carefully.
slide.axle.through.heater.body.as.shown.
in.Figure.5.
4.. Slide. second. wheel. onto. axle. from. op-
posite.side.of.heater.
5.. Have.another.person.secure.wheel.and.
axle.from.other.side.of.heater.while.gently.
tapping. second. push. cap. onto. end. of.
axle.
Top
1.. Remove.4.brackets,.(8).1/2".black.screws.
and. (8). 3/8". screws. from. hardware.
packet.
2.. Lay.top.upside.down.on.a.clean.surface..
Attach.4.brackets.to.top.with.1/2".black.
screws.
Bracket
Slots
120193-01A
aSSeMBLy
Continued
Figure 5 - Installing Axle and Wheels
3.. Turn. top. over. and. carefully. place. over.
4.. Attach.brackets.to.heater.with.3/8".screws.
Figure 6 - Attaching Top
www.desatech.com
Heater.
Front
Push.Cap
heater,.positioning.brackets.through.slots.
in.heater.front.and.rear.panels.
Top
Bracket
Axle
Wheel
Bracket
Screws
9