Cooling Fluid Check; Stop Light Checks; Direction Turn Checks; Rear View Mirror Check - Benelli BN251 Manual Usuario

COOLING FLUID CHECK

Cooling fluid level
Before using the bike, always check the
level of cooling fluid. It is also necessary
to change cooling fluid at the intervals
specific in the periodical maintenance
and lubrication sheet.
To check the level of the cooling fluid:
1. Place the vehicle on a flat surface and
keep it upright.
2. Remove rear saddle.
3. Remove the two screws "A" and then
remove the front saddle.
A
4. Remove the two side cover left and
right by the screws "B".
C
B
5. Remove the tank cover by the 4
screws "C".
6. Check the level.
The liquid level must be between the
min. and max. levels.
If this is not the case, reset the level as
described in the specific section.
NOTE:
The level of liquid refrigerant must be
measured while the engine is cool, since
it varies according to engine temperatu-
re.
91

STOP LIGHT CHECKS

rear brake pedal alternatively and
make sure that the light switches on.
damaged or dirty.

DIRECTION TURN CHECKS

that they flash.

REAR VIEW MIRROR CHECK

Sit in the saddle and adjust the mirrors
for a correct vision behind you.
or dirty.
EN