Adjust The Direction Of The Lens - Axis M31 Serie Guia De Instalacion

AXIS M31 Network Camera Series Installation Guide
8. Route the camera's Ethernet cable through
the hole.
9. Place the camera on the adaptor in the right
direction and fasten with four screws.
Mount on a flat surface with an adaptor
1. Place the adaptor on the mounting surface and position the slot for
the cable where appropriate.
2. Fasten the adaptor with three screws appropriate to the surface
material.
3. Fix the camera's Ethernet cable in the slot in the adaptor and press
into place.
4. Place the camera on the adaptor, and turn the camera so the lens
faces the correct direction.
5. Adjust so the screw slots on the camera are aligned with the screw
holes in the adaptor, and attach the 4 screws (torque < 2.5 Nm).
6. Attach the network cable to the camera's Ethernet cable.
Note:
Do not use a countersunk screw head.

Adjust the direction of the lens

Fit the lens tool to the lens holder, and adjust the position of the lens by pointing the lens tool
handle in the preferred direction (See illustration on page 4). This can be done vertically from 0 to
90 degrees, and 30 degrees to the left or the right on either side in increments of five.
The lens holder can also be rotated to adjust the image.
Align the ribs in the lens tool horizontally so that the image is also aligned
horizontally.
Note:
The '0' mark on the lens holder indicates the bottom of the image and the '180'
mark indicates the top, see Hardware overview above. If the camera is mounted
upside down, adjust so the '0' mark is on top and the '180' mark below the lens.
The line inside of the bottom of the optic holder
should be aligned with the line at the center of the
optic mount.
Page 7
Align ribs horizontally
line
line