Adjust The Lens; Complete The Installation - Axis P3343-VE Guia De Instalacion

Page 12

Adjust the Lens

Open the Live View page in the web interface and
make the following adjustments to the camera:
1. Loosen the locking screw and tilt adjustment
screws.
2. Turn the lens (with the lens holder) to the
desired position. Make sure the horizon lines
on either side of the lens are aligned
horizontally and the single slit between the
horizon lines is pointing down.
3. Once satisfied, gently tighten the locking
screw and tilt adjustment screws to secure the
camera's position.
4. Open the Focus Adjustment page in the Web
interface under Setup > Focus & Zoom, and follow the on-screen instructions. Use the image
window to adjust the focus and zoom.
Go to Setup > Video & Image > Advanced in your web interface and see the online help for
more information.
Note:
Due to the dome's refraction, the image may appear slightly out of focus once the dome has been
placed. To correct this go to the Focus Adjustment page in the Web interface under
Setup > Focus & Zoom, and adjust the focus again.
Warning!
Adjusting the focus and zoom manually can damage the lens.

Complete the installation

1. Rotate the black protective shield inside the dome cover
so it is aligned with the camera's position.
2. If required, attach the weather shield to the camera before
you attach the dome cover. To do this remove the two
screws in the dome cover. Transfer the washers from these
screws to the two long screws provided. Attach the weather shield using the two long screws.
3. Attach the dome cover to the unit casing by tightening the 4 screws.
AXIS P3343-VE/P3344-VE Installation Guide
Horizon line
Tilt adjustment screw
Locking screw
Black protective
shield
Tilt adjustment screw
This part
must face down