Removing The Stand; Reattaching The Stand; Removing The Handle - Saltillo TouchChat Express 8 Guía De Usario

Removing the Stand

If you do not want to use the stand, you can remove it from the back of the device.
1. Position the stand so that it is not latched in place.
2. Insert the tip of a flat-head screwdriver into one of
the hinges as shown.
3. Press in on the end of the leg until the leg disengages
from the holder.
4. Pull the leg out of the holder.
5. Pull out the other leg.
Note: Be sure to store the stand in a safe location in case
you want to reattach it later.
When the stand is removed, it becomes a potential hazard for
choking or for poking the eye.

Reattaching the Stand

If you remove the stand, you can reattach it easily at any time.
1. Squeeze near the end of one leg of the stand with your thumb and index finger.
2. Push the leg into the holder until it snaps into place.
3. Repeat for the other leg.

Removing the Handle

If you do not plan to use the handle, you can remove it by removing the screws that hold it in place.
The handle and screws are potential choking hazards.
TouchChat Express User's Guide
Remove the two screws
88