Sears Craftsman 536.885921 Owner’s Manual página 9

ASSEM LY
TO INSTALL HEADLIGHT
The headlight is mounted on the right side of the upper
handle., it is installed upside down for shipping purposes
® Remove the pivot bolt nut, lockwasher and saddle
washer (Fig. 6A) from the headlight mounting bracket
Remove headlight assembly and replace on top side
of upper handle with saddJe washer, Jockwasher and
pivot bolt nut as shown in Fig 6B Tighten nut securely
(See Headlight Repair Parts, page 31).
® Tie the headlight cable to upper and lower handles
with the plastic cable ties supplied in the parts bag by
threading the pointed ends of each tie through the
square end and putling tightly around the headlight
cable and the handle
NOTE: One side of the plastic tie has small notches in it,
while the other side is smooth. The notched side must be
on the inside o! the loop which is formed when the ends are
put together:
@ Try to loosen the cable tie If it can be loosened, it has
been attached with the smooth side on the inside of
the loop. Removethe cable tie and reverse its direction
@ Cut off excess plastic tie
TO INSTALL THE SHIFTER LEVER
O Stand the snow thrower up on the lronl of the auger
housing, as shown in Fig.7A Note: Place a piece of
cardboard under front to prevent paint damage to
auger housing.
• Cut the plastic tie which holds the shifter lever
assembly to the shift bracket (Fig 7B)
• Remove the iocknut, washer, spring and bolt
(Fig 7D)..
@ Reposition the shifter lever into the slot in the
control panel, as shown in Fig 7C, and reinstall the
bolt, spring, washer and the Iocknut
• Tighten the locknut until 1/8" to 3/t6" (2 or3 threads)
of the bolt protrude past the locknut
® Thread the shifter lever knob onto the threaded end
of the shifter lever until it is tight (Fig 7D)
• Move the shifter lever through all the speeds to
ensure proper tension of the spring If the shifter
lever sticks in any ol the notches, loosen the
locknut 1/4 turn at a time until the shifter lever moves
freely
• Return the snow thrower to the normal operating
position.
TO CHECK/ADJUST CLUTCH
CONTROL CABLES
The control cables attached to the auger clutch lever and
traction clutch fever may need to be adjusted before you
use your snow thrower
For instructions on checking or adjusting the control
cables, see To Adjust Clutch Control Cables paragraph on
page 19.
PIVOT
_'IVOT
BOLT
NUT
BOLT
TIES
FIG_ 6A FIG. 6B
SHIFTER
LEVER
CONTROLPANEL
SHIFTER LEVER
SHIFTER
SHIFTER KNOB
/
SPRING
9
C
WASHER
D
lib TO _t6 INCH OF
EXPOSEDTHREADS
FtG.7