Checking Signal Strength; Unsuccessful Connection - Honeywell VisionPRO 8000 Manual De Instrucciones

Checking signal strength

You can check signal strength at any time
after the thermostat is connected to the
Wi-Fi network by pressing
Setup.
Signal strength is 75%–100%
Signal strength is 50%–75%
Signal strength is 0%–50%

Unsuccessful connection

If you are unsuccessful in connecting the thermostat to the Wi-Fi network, you
will see a Connection Failed screen. Press
connection. Here are three specific reasons the connection might be unsuccessful.
For all Connection Failed screens, pressing
Invalid Password
The password you entered is invalid. Check that you have the right password and
try again.
No IP Address
The thermostat was unable to obtain an IP address from the router. Verify the
router is correctly set up to automatically assign IP addresses. This connection can
take several minutes. If there is still no connection, remove the thermostat from the
wallplate for 10 seconds, then snap it back into place.
No Internet Link
The thermostat connected to the Wi-Fi network but was unable to establish a
connection to the internet. Check the router settings and try again. Make sure the
Ethernet cable is plugged into the router and try rebooting the router if necessary.
33-00066EFS—05
MENU then Wi-Fi
t
19
Wi-Fi Network:
YourNetwork
button for other tips about this failed
Done
will return to the Menu screen.
M35365