Leister EXAMO 300F USB Instrucciones De Funcionamiento página 20

Readiness for working
• Open storage case
• Connect enclosed power cable to socket (1).
• Connect the machine to the line/mains
• Pull out clamping lever (9) un till it is locked
• Turn-on main switch (2)
– Position of sliding carriage is not at spacer (13)
– Position of sliding carriage is at spacer (13)
Test parameter
• Set the test parameters using the following keys:
SET
– +
‹‹ ››
Set speed
N lbf
SET
– +
‹‹ ››
Display unit
• Speed:
• Initial Length: Clamping distance in mm or Inch of the device jaws after actuation with the key
• Initial Tension: Level of initial tension. When the set initial tension is achieved, the evaluation of the tensile
test starts. If the initial tension is set to O, the test evaluation can be started by pressing the
• Exit menu by pushing
• When setting the initial length, the force display may show the value ≠ 0. Reason: Influence of temperature
on the equipment and/or force on the clamping jaws (11) which are close to the housing of the drive
motor and circuit board (15).
• When starting the test, the force values are reset to 0.
Version with USB port has more menu items (see operation of USB port).
20
– Press < <, for Initialize appears on display (4)
– Push key
and sliding carriage (12) moves to spacer (13).
– Display (4) shows standard mode
– Display (4) shows standard mode
SET
Set Initial Length
mm inch
SET
Display unit
Test speed in mm / min or inch /min (depending on the settings below)
+
.
››
The jaw spacing can be corrected at any time with the key
The absolute position of the sliding carriage (12) (jaw spacing) appears on the display (4).
key
SET
, Wait for Initialize appears on display (4)
–
‹‹
SET
– +
‹‹ ››
Set Initial Tension
– +
‹‹ ››
– +
‹‹ ››
– or + .
‹‹ ››
› Start key.

–
oder
‹‹