Operating; Starting A Cut; Breaking; When Taking A Break - Atlas Copco TEX 3 Instrucciones De Seguridad Y De Funcionamiento

Safety and operating instructions
TEX 05P, TEX 09PS,
TEX 10PS
Stop the machine by releasing the trigger. The trigger
returns automatically to the stop position.

Operating

Starting a cut

♦ Stand in a stable position with your feet well away
from the inserted tool.
♦ Press the machine against the working surface
before you start.
♦ Start collaring at such a distance from the edge
that the machine is capable of breaking the
material without levering.
♦ Never try to break off too large pieces. Adjust the
breaking distance (A) so that the inserted tool does
not get stuck.

Breaking

♦ Let the machine do the work; do not press too
hard.
♦ Avoid working in extremely hard materials for
example granite and reinforcing iron (re-bar) which
would cause substantial vibrations.
♦ Any form of idling, operating without insertion tool
or operating with an uplifted machine must be
avoided.
♦ When the machine is lifted, the start and stop
device must not be activated.
♦ Check regularly that the machine is well lubricated.
18
TEX 12PS
A
© 2012 Atlas Copco Construction Tools AB | No. 9800 0799 90c | 2012-12-31
TEX 3, 05P, 09PS, 10PS, 12PS

When taking a break

♦ During all breaks you must place the machine in
such a way that there is no risk for it to be
unintentionally started. Make sure to place the
machine on the ground, so that it can not fall.
♦ In the event of a longer break or when leaving the
workplace: Switch off the power supply and then
bleed the machine by activating the start and stop
device.
Original instructions