Mounting Precautions (For Sharp Dealers And Service Engineers) - Sharp PN-UH861 Manual De Instalación

Mounting Precautions (For SHARP dealers and service engineers)

• When installing, removing or moving the monitor, ensure that this is carried out by at least 2 people. (PN-UH861: at least 3
people.)
• Be sure to use a wall-mount bracket designed or designated for mounting the monitor.
• This monitor is designed to be installed on a concrete wall or pillar. Reinforced work might be necessary for some materials
such as plaster / thin plastic board / wood before starting installation.
• This monitor and bracket must be installed on a wall which can endure at least 4 times or more the weight of the monitor.
Install by the most suitable method for the material and the structure.
• To attach a VESA-compliant mounting bracket, remove the screws attached to screw holes for mounting brackets. Do not use
the removed screws to attach the mounting bracket. (PN-UH861 ONLY)
• To attach a VESA-compliant mounting bracket, use M8 [PN-UH861] or M6 [PN-UH551/PN-UH501/PN-UH431] screws that
are 11/16 inch (18 mm) to 13/16 inch (20 mm) [PN-UH861] or 5/16 inch (8 mm) to 3/8 inch (10 mm) [PN-UH551/PN-UH501/
PN-UH431] longer than the thickness of the mounting bracket.
• Do not use an impact driver.
• When moving the monitor, be sure to hold the parts marked by
product damage, failure, or injury.
[PN-UH861]
• After mounting, please carefully ensure the monitor is secure, and not able to come loose from the wall or mount.
• Do not use any screw holes other than those for mounting brackets, located on the rear of the monitor, for installation.
10
E
11/16 inch (18 mm) to 13/16 inch (20 mm) [PN-UH861]
5/16 inch (8 mm) to 3/8 inch (10 mm) [PN-UH551/PN-UH501/PN-UH431]
Screws (M8 [PN-UH861] or
M6 [PN-UH551/PN-UH501/PN-UH431])
Mounting bracket
Monitor mounting
below. Do not hold the LCD panel. This may cause
[PN-UH551/PN-UH501/PN-UH431]