PIEPS DSP Pro ICE Manual Del Usuario página 13

QuICKSTART In 3 STEP S
Your pIEpS DSp pro ICE
is ready to use directly out of the box!
Step 1:
Putting on the carrying
harness, place the shoulder
strap loop over head and
shoulder. Lead the body strap
around your back, fix the quick
fastener and adjust to the
Carrying recommendation:
proper length.
carrying the PIEPS DSP PRO ICE using the supplied
carrying harness. The neoprene-material is water
Step 2:
repellent, for the functional control take a look on
Switch on the PIEPS DSP
the transmit light, the "Quick-Pull-System" enables
PRO ICE (SEND) and wait for
you to access the PIEPS DSP PRO ICE very quickly in
the results of the self-check.
case of emergency. Insert the beacon with the display
towards the body for best protection (see picture).
Step 3:
Put the PIEPS DSP PRO ICE
back into the carrying system
and enjoy your tour.
„Quick-Pull-System"
WARnInG!
The volume level of an avalanche There is also the option to carry the PIEPS DSP
transceiver can be up to 100 dB PRO ICE with the supplied hand loop in a securely
closeable trouser pocket without a protective case.
(decibels), and may cause damages
to your hearing! Make sure that The hand loop can be fixed around your wrist during
there is always a minimum distance the search to rule out losing the PIEPS DSP PRO ICE.
of 50 cm between the avalanche
transceiver and your ears!
24 | 06/15
PIEPS recommends
SWIT CHInG On | SEL F-CHE CK
Press the button „Lock" and push the main switch up to the position „SEARCH". Release the
button „Lock" and push down the main switch till latching noticeable in the position „SEND".
The PIEPS DSP PRO ICE is now in SEND-mode.
During power-on, the PIEPS DSP PRO ICE will carry out an extensive self-check. All relevant
hardware-components are tested and the latest firmware is displayed. During the self-check, a
minimum distance of 5 meters should be maintained to other beacons, and any electronic or
magnetic interference.
If the self-check is successful, "OK" is indicated on the display. In the event of a device warning,
an alert signal sounds and the display indicates "E" in combination with a warning-code
(overview table in chapter warning-codes).
If the warnings are still shown in an interference-free area the PIEPS DSP PRO ICE is not fully
functional. Bring your PIEPS DSP PRO ICE to a PIEPS authorized service center.
Display Display Display
Firmware-Version Self-check OK Self-check error
BE ACOn-CHE CK | GROuP- CHECK
Despite the extensive self-check, PIEPS recommends that all users perform a beacon check
before each tour! Your PIEPS DSP PRO ICE is equipped with a group-check-function. A check
is simple and efficient, it tests to be sure your partners avalanche transceiver is sending a signal
and whether the frequency is in compliance with standards.
06/15 | 25