Spare Parts - Fellowes PowerTrim A3 Manual De Instrucciones

BLADE UNIT REPLACEMENT
Unplug PowerTrim. Remove
SafeCut™ Guard
(magnetic catch).
CHANGING CUTTING STRIPS
Unplug PowerTrim. Remove
SafeCut™ Guard (magnetic
catch).
If you are in doubt of how to replace these spare parts or where to purchase them please call Fellowes customer service or your
service engineer.

SPARE PARTS

The following spare parts are available for PowerTrim:
Item
1 blade / 2 cutting strips kit
W.E.E.E.
PowerTrim_v2.0_All_Langs.indd 7
Unscrew 2 cross head
(Phillips) screws on
either side of the cutter
element.
Make sure SafeCut™
Clamp is open.
Order number (CRC)
54125
This product is classified as Electrical and Electronic Equipment. Should the time come for you to dispose of
this product please ensure that you do so in accordance with the European Waste of Electrical and Electronic
Equipment (WEEE) Directive and in compliance with local laws relating to this directive.
For more information on the WEEE Directive please visit www.fellowesinternational.com/WEEE
Take out cutter element
by pulling the button
on the element.
Replace with new cutter
element (#54125).
Open small safety catches to release the cutting strip. Turn
cutting strip over (left / right, top / down) to use other side
of the strip . When all areas have been used, replace cutting
strip with new one from spares pack (#54125). Re-secure
cutting strip and SafeCut™ Guard again.
Required
After ca. 5000 cuts (blade unit) / 1000 cuts (strips)
Insert new cutter
element and tighten
screws securely again.
Re-secure SafeCut™
Guard.
7
12/02/2009 13:59:53