Fellowes PowerTrim A3 Manual De Instrucciones página 9

TROUBLESHOOTING
Problem
No lights showing on Cutting base or
Scissor Icon
Cut button does not work when pressed
(No function when pressed)
Paper is cut but cutting head still moves
along machine still continues to cut
Can't replace cutting strips - not enough
room to lift them
Poor cut quality (Cuts are not very sharp –
edge of cut items not straight)
LED warning symbols
Scissor icon is flashing in alternate blue
and red
Scissor icon light is red - no illuminated
cutting base
Scissor icon light not on
PowerTrim_v2.0_All_Langs.indd 9
Possible cause
Machine is not switched on
Machine not plugged in
SafeCut™ Guard not in place
SafeCut™ Guard not closed
PowerTrim is set to complete 6 cut cycles as
default.
SafeCut™ Clamp closed
Cutting strips could be worn out
Cutting blades could be worn out
SafeCut™ Clamp is open when cutting is not
yet complete
Motor is too hot when doing continue cut
SafeCut™ Guard is open or Power not
switched on
Solution
Switch on machine at rear next to plug
inlet and at the mains socket
Move the machine to a cooler and dry
area
Ensure that SafeCut™ Guard is
securely in place
Ensure that SafeCut™ Guard is
closed
To stop PowerTrim before 6 cycles have
been completed, just press the "scissor"
touch button again
Open SafeCut™ Clamp
Turn cutting strip over as described
above to use other side, or replace with
spare part CRC 54125
Replace (with spare part CRC 54125) as
described above
Close SafeCut™ Clamp
Let trimmer cool down
Make sure power is switched on and
SafeCut™ Guard is closed
12/02/2009 13:59:54
9