Ventilation Speeds Configuration - Duran Electronica 203 PLUS Serie Manual De Instalacion Y Uso

2. When it blinks, press CHANGE VENTILATION LEVEL
level appears. Wait a few seconds.
3.
4.

2 VENTILATION SPEEDS CONFIGURATION

It is necessary to install a second speed module per module line for the 2nd ventilation
speed to be activated
The control unit is programmed at the factory according to the following parameters:
Ventilation Level
Alarm Level
Ventilation Mode
Acoustics
Checking the level programmed
1. Press CHANGE VENTILATION LEVEL
on the display:
Ventilation Initial level
Level (blinking)
Changing ventilation level
Remember that only the 1
and alarm level are automatically set, according to the following table:
42
© 2011 DURAN ELECTRONICA S.L.
All rights reserved · www.duranelectronica.com
will then appear, followed by the new ventilation level selected.
will appear, followed by the alarm level assigned automatically.
1 ventilation Ventilation
st
speed Level
ventilation level can be selected, as the 2
st
1st speed 50 ppm/ 2nd speed 75 ppm
100 ppm
Automatic
Activated
once and observe the sequence
2 ventilation Ventilation
nd
speed Level
until the desired
Alarm Assigned
level level
ventilation level
nd