Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
[] Initial
Setup
Thissection will guideyouthroughtheunit'sinitialsettingwhichincludes
selecting a languageforyour on-screen menuandautochannel s can,
whichautomatically scans andmemorizes viewable channels,
Before you begin:
Makesureif the unit is connectedto antenna or cable.
After making
all the necessary connections,
press
[POWER] to turn on the unit.
_'OWER
• This operation
maytake
a few moments.
2
Use [Cursor l/Y]
to select the on-screen
language
from the choices on the right side of the TV screen.
(English / Espa_ol / Fran_ais)
or
V ¸
• "Initial Setup" menu on step 3 will be displayed
in the
selected language
after you press [ENTER].
3
Use [Cursor l/V]
to select "Air" for TV channels
or
"Cable" for CATV channels, then press [ENTER].
!
oP
• Scanning
and memorizing
of channels start
automatically.
Note:
• Ifyou connect the cable system directly, contact the CATV
installer.
• Ifyou press[POWER] or [SETUP] during auto channel
scan, this setting will be canceled.
• The initial auto channel scan function can be executed
for either "Air" or "Cable" only once. When you change the
connection (Air/Cable), set auto channel scan again. (Refer
to page 14.)
• Youcan cancel or exit the initial auto channel scan menu
bypressing [SETUP].
• If there is no signal input from the antenna terminal and
no operation for several seconds after you turn on the unit,
"Helpful Hints" appears. Follow the instructions listed on
the TVscreen.
!,,7_
ii !!i,i_]i
i 7 ¸
ii 111!7
IO
! i71::
ii:_!!ii_i
• When the scanning
and memorizing
are completed,
the lowest memorized
channel
in the broadcasting
will be displayed.
iiTiii:ii
EN
Publicidad
Tabla de contenido
