Channel Selection; Sleep Timer - Sylvania LC420SS8 Manual Del Usuario

[] Channel Selection
Selectchannels b y pressing [CH•/V] or [the Numberbuttons].
[] Volume Adjustment
Thissection describes h owto adjustthe volume.Themutefunction, w hich
turnsthesoundoff andon,isalsodescribed.
• To select the memorized channels, use [CH •Iv] or
[the Number buttons].
• To select the non-memorized channels, use
[the Number buttons].
To Use [the Number buttons]
When selecting analog channel 12
- When selecting digital channel 12-1
Be sure to press [-] before entering the minor
channel number.
• Press [CH. RECALL] to return to the previously
viewed channel.
About digital TV broadcasting:
With its high definition broadcast, digital broadcasting
far surpasses analog broadcasting in both its picture
and sound quality.
What is the minor channel?
By using high compression technology, digital
broadcasting offers a service that enables multiple
signals to send simultaneously,
Therefore, you can select more than one program per
major channel since digital broadcasting technology
distinguishes between multiple channels broadcast by
a single network,
NTSC (analog mode) [Air Time] ATSC (digital mode)
18:00
18:30
19:00
19:30
20:00
20:30
major cha_nel
,,_ : change automatically
_:> :change manually by using [CH •Iv]
• I
minor channel
Note:
• "No Signal" will appear on the TVscreen after the minor
channel broadcast is over.
Use [VOL. I ] to adjust the audio volume,
• The volume bar will be displayed at the bottom of
the TV screen when adjusting the volume,
• The volume bar display will automatically disappear
in a few seconds,
Press [MUTE D_] to turn off and on the sound,
MU;_
\
• "Mute" is displayed on the TV screen for a few
seconds,
Press [MUTE D_:]again or [VOL. _I ] to recover the
original volume,
[] Sleep Timer
Thesleeptimer can beset to automatically turn offthe unit after an
incremental period of time.
1 Press [SLEEP] to set the sleep timer.
• Sleep timer display appears on the %/screen,
2 Press [SLEEP] repeatedly to change the amount of time
until shut off,
i,i :
• You can set your unit to turn off after a set period of
time (from 30 to 120 minutes),
• Each press of [SLEEP] will increase the time by 30
minutes.
• After set up, the sleep timer display can be called up
for checking by pressing [SLEEP],
To Cancel the Sleep Timer
Press [SLEEP] repeatedly until "Sleep Off" is displayed
on the TV screen,
Note:
• The sleep timer setting display will automatically
disappear in a few seconds.
• When you disconnect the unit from the AC outlet or when
a power failure occurs, the sleep timer setting will be
canceled.
EN