Celestron MICRODIRECT 44316 Manual De Instrucciones página 7

C. TIME-LAPSE CAPTURE
Your MicroDirect allows you to set the device to take images
+
over a defined time period. This is referred to as Time-Lapse.
You will first select the number of still images or Lapse
+
Num you want your device to take. This can range from 2
to 999 images.
Use the Down button (9) to scroll through the numbers from
+
0 to 9. When satisfied with the first digit, press the Mode
button (6) to jump to the next digit.
Again, using the Down button (9), set that digit.
+
Once the number of still images has been chosen, press the
+
Mode button (6) to move to the Lapse Time choice.
The Lapse Time determines the amount of time that will
+
pass between each still image capture.
Set these numbers using the same method as above for the
+
Lapse Num.
The choices are in seconds and range from 1 second to 999 seconds.
+
This, along with the number of images, will determine your overall length of time for your time lapse.
+
For example: If you choose to take 999 total images and the interval between each is 999 seconds you will have 277 hours
+
documented. 999 seconds = 16.65 minutes. Multiply that by 999 (images) =16,633.35 minutes. 16,633.35 / 60 (minutes
per hour)= 277 hours or 11.55 days of documentation.
Once you have set your number of images and interval, press the Capture/OK button (8) to confirm.
+
Press the Menu button (7) to return to the streaming image.
+
Press the Capture button (8) to start the time lapse.
+
Once all frames have been taken in the Time Lapse mode, the MicroDirect
+
normal preview mode.
NOTE: The AUTO POWER OFF time needs to be set to a number higher than the set Time Lapse time. See section on AUTO POWER
OFF FEATURE and make sure to do your calculations correctly.
1080p HD microscope will revert back to the
®
7
ENGLISH I