Kensington KeyCover Plus Guía Rápida página 9

at least 30 % charge remaining. To check the charge level of your KeyCover press the battery
indicator button.
• Avoid frequent full discharges because this puts additional strain on the battery in the KeyCover.
Charge your KeyCover between uses even if it is not fully discharged. The lithium-polymer battery
used in this product has no "memory effect." Therefore, several partial discharges with frequent
recharges are better than one full discharge, and will help prolong the life of your KeyCover. Short
battery life in laptops is mainly caused by heat, rather than charge/discharge patterns.
• Do not store your KeyCover at elevated temperatures (such as in your car) or in high humidity.
Disposing of your KeyCover
• Do not incinerate or dispose of your KeyCover in a fire or microwave.
• Do not dispose of your KeyCover as ordinary refuse, as it contains a lithium-polymer battery.
Consult your local municipal or civil authority for instructions on correctly disposing of a
lithium-polymer battery.
• In the USA and Canada: This mark
Battery Recovery Corporation ("RBRC"). When you are ready to dispose of the KeyCover, please
contact the RBRC at 1-800-8-BATTERY or www.rbrc.org.
FEDERAL COMMUNICATIONS COMMISSION RADIO FREQUENCY INTERFERENCE STATEMENT
This device has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses. and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment causes
harmful interference to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
MODIFICATIONS: Modifications not expressly approved by Kensington may void the user's authority to operate the
device under FCC regulations and must not be made.
SHIELDED CABLES: In order to meet FCC requirements, all connections to equipment using a Kensington input device
should be made using only the shielded cables.
FCC DECLARATION OF CONFORMITY COMPLIANCE STATEMENT
This product complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) This device must accept any interference received, including interference
that may cause undesired operation. As defined in Section 2.909 of the FCC Rules, the responsible party for this device
is Kensington Computer Product Group, 333 Twin Dolphin Drive, Redwood Shores, CA 94065,USA.
INDUSTRY CANADA CONFORMITY
This device has been tested and found to comply with the limits specified in RSS-210. Operation is subject to the
following two conditions: (1) This device may not cause interference, and (2) This device must accept any interference,
including interference that may cause undesired operation of the device.
This Class [B] digital apparatus complies with Canadian ICES-003.
CE DECLARATION OF CONFORMITY
Kensington declares that this wireless product model is in compliance with the essential requirements and other
relevant provisions of R&TTE directive (1995/5/EC) and other applicable EC directives. For Europe, a copy of the
Declaration of Conformity for this product may be obtained by clicking on the Compliance Documentation link at
www.support.kensington.com.
INFORMATION FOR EU MEMBER-STATES ONLY
The use of the symbol indicates that this product may not be treated as household waste. By ensuring this
product is disposed of correctly, you will help prevent potential negative consequences for the environment
and human health, which could otherwise be caused by inappropriate waste handling of this product. For more
detailed information about recycling of this product, please contact your local city office, your household
waste disposal service, or the shop where you purchased the product.
Kensington and the ACCO name and design are registered trademarks of ACCO Brands. The Kensington Promise is a
service mark of ACCO Brands. KeyCover Plus is a trade mark of ACCO Brands. iPad and Siri are registered trademarks of
Apple Inc., registered in the U.S. and other countries. Bluetooth is a registered trademark owned by Bluetooth SIG. All
other registered and unregistered trademarks are the property of their respective owners.
© 2013 Kensington Computer Products Group, a division of ACCO Brands USA LLC. Any unauthorized copying,
duplicating, or other reproduction of the contents hereof is prohibited without written consent from Kensington
Computer Products Group. All rights reserved. 01/14
indicates your KeyCover can be recycled by the Rechargeable
7