Tools Required - Sears Craftsman 536.881400 Manual Del Usario

Contents of Parts Bag (actual size)
1 - Owner's Manual (not shown)
1 - Packet of Fuel Stabilizer (not shown)
1- Container 5W30 Oil
,_ WARNING: Always wear
safety glasses or eye shields
while assembling snow
thrower.
TOOLS REQUIRED
1 - Knife to cut carton
Figure 1 shows the snow thrower in the
operating position.
References to the right or left hand side
of the snow thrower are from the view-
point of the operator's position behind
the unit.
Auger Drive Lever _.
Auger
Drive Cable
Crank
Chute
Deflector
Figure 1
HOW TO REMOVE FROM THE
CARTON
1. Locate and remove container of
Craftsman 5W30 oil.
F-051009C
2. Locate all parts packed separately
and remove from the carton.
NOTE: Place fuel stabilizer in a
safe place until needed for storage.
3. Remove and discard the packing
material from around the snow
thrower.
4. Cut down all four corners of the car-
ton and lay the panels flat.
5. Loosen the knobs holding the upper
handle to the lower handle (See
Figure 2). Raise the upper handle to
the operating position. Tighten the
knobs,
6. Roll snow thrower off the carton by
pulling on the lower handle,
CAUTION: DO NOT back over
cables.
7. Remove the packing material from
handle assembly, Remove the lower
insert from the axle.
Upper Handle
\
Knob
Figure 2