General Recommendations - Sears CRAFTSMAN 536.881501 Manual De Propietario

CUSTOMER RESPONSIBILITIES
SERVICERECORDS
Fill in dates asyou Before Every Every Every Every
completeregular Each 8 25 50 100 Each Before
service. Use Often Hours Hours Hours Hours Season Storage
Change Engine Oil
Check and Clean Spark
Plug
Clean and Inspect
Spark Arrestor
Check Fuel
Check Ad ustment of I I
Auger Controt Cable _'
GENERAL RECOMMENDATIONS
The warranty on this snow thrower does
not cover items that have been sub-
jected to operator abuse or negligence.
To receive full value from the warranty,
the operator must maintain the snow
thrower as instructed in this manual.
Some adjustments will need to be made
periodically to properly maintain your
snow thrower.
Maintenance, replacement, or repair of
the emission control devices and sys-
tems can be performed by any non-road
engine repair establishment or individu-
al. Regular maintenance will improve the
performance and extend the life of the
engine.
,_ WARNING: Do not strike the
flywheel with a hammer or a
hard opject, If done, the fly-
wheel can shatter during operation,
Do not tamper with the governor
spring, links or other parts to in-
crease engine speed.
AFTER EACH USE
• Run the machine to clear the auger
of snow.
F-0510100
• To prevent freezing of the auger or
controls, remove all snow and slush
from the snow thrower.
• Check for any loose or damaged
parts.
• Tighten any loose fasteners.
• Check and maintain the auger.
• Check controls to make sure they
are functioning properly.
• If any parts are worn or damaged,
replace immediately.
LUBRICATION BEFORE STORAGE
16
/
Lubricate
control flang,
flange with a clinging type
grease such as Lubriplate.
Figure 15