Sears Craftsman 536.270300 Manual Del Usario página 11

Tabla de contenido

Publicidad

OPERATION
ATTACHMENTS
This unit can use many
different
attachments.
See the attachment
page
in this
book.
This
unit
can
pull
attachments
like
a lawn
sweeper,
a lawn aerator,
a hopper
spreader,
or a small trailer.
This
unit can not use attachments
that engage
the ground
like a plow, a
disk harrow,
or a cultivator.
For all pull-behind
attachments
or trailers, the maximum gross
weight
is 200 pounds.
Gross weight
is the weight
of the attachment
or trailer
and any load that might be on or in it.
Do not operate
on a slope that is greater
than
10 degrees
when
using a pull-behind
attachment
or trailer.
We have included
a slope
guide in this book to help you determine
the slope on which you will
be operating
your unit. Never allow someone
to stand or ride on or
in an attachment
or trailer.
ELECTRICAL
SAFETY
SYSTEM
The electrical
system
has two primary
components,
an Operator
Presence
System
and a Select
ReverseT"
system.
Operator
Presence System (Seat)
The seat has an Operator
Presence
System
to shut off the engine
when the operator
leaves
the seat. This system
is not intended
for
regular
use in stopping
the engine
or the blade(s).
Before leaving the
seat, move the blade
rotation
control
to the DISENGAGE
position,
shift to neutral,
set the parking
brake
and stop the engine.
Select Reverse'" System
The Select
Reverse
T'_ system
will allow
the mower
blade(s)
to
continue
to rotate when traveling
in reverse.
See "How To Operate
The Ignition
Key Switch"
and "How To Start The Engine"
for further
details.
HOW TO OPERATE
THE IGNITION
KEY SWITCH
Use the ignition key switch to start and stop the engine. When you
start the engine and release the ignition key, the ignition key switch
will automatically default to the recommended
RUN-MOW position
for normal mowing.
START
- Use this position to start the engine.
RUN-MOW
- When you start the engine and release the ignition
key, the ignition
key switch
will automatically
default
to the
recommended
RUN-MOW
position
for normal
mowing.
In the
RUN-MOW
position, the system will stop the engine and the
blade(s) when the speed control pedal/shift
lever is put in the
reverse position.
SELECT
REVERSE"
-
The
optional
Select
Reverse T_
position will allow the mower blade(s) to continue to rotate when
traveling
in reverse.
Always
go back to the
recommended
RUN-MOW position for normal mowing when operation in Select
Reverse T`_is not absolutely necessary. NEVER use the Select
ReverseT_ option if children are on or near the property.
(_
WARNING:
Operators
are strongly discouraged
from using this option unless the operator
de-
cides such operation is absolutely necessary and
that safe precautions
are taken. Never use the Select Re-
verse _ option if children are on or near the property. Always
look down and behind before and while backing. After using
the Select Reverse _ position, move the ignition key back to
the RUN-MOW position.
STOP
- Use this position to stop the engine.
F-050607L
11

Publicidad

Tabla de contenido
loading

Tabla de contenido