Tabla de contenido
Publicidad
SERVICE AND ADJUSTMENT
HOW TO REMOVE
THE MOWER
HOUSING
1.
Move the attachment clutch to the DISENGAGE
position.
2.
Move the lift lever to the level adjustment position (Figure 29).
NOTE: Make sure the lift lever
is
locked
in
the
LEVEL
ADJUSTMENT
position.
3.
Remove the hair pins and the
washers from the rear suspen-
sion arms (Figure 30). See il..................
lustrations "C" and "D".
Level Adjustment
4.
Remove the hair pins and wash-
Position
Figure 29
ers from the suspension
links.
See illustrations "A" and "B".
5.
Disconnect the extension
spring from the blade control rod.
See illustration "E".
6.
Disconnect
the front
hanger
from the frame support. See
illustration "F".
7.
Remove the mower drive belt from the stack pulley. See
i!lustration "G".
8.
Pull the mower housing away from the right side of the unit,
9.
To operate without the mower housing, move the lift lever to the
TOP position.
HOW TO INSTALL
THE MOWER
HOUSING
1.
Push the mower housing under the right side of the unit.
2.
Put the mower drive belt around the stack pulley. Make sure
the '_/" side of the mower drive belt is against the stack pulley.
Also, make sure the mower drive belt is not twisted,
3.
Attach the front hanger to the frame support with the hanger
rod. Fasten with the fasteners as shown, See illustration "F".
4.
Make sure the mower drive belt is between the stack pulley
and the two belt guides. See illustration "G".
5.
Attach the suspension
links to the lifter assembly.
Fasten
with the washers and hair pins, See illustrations "A" and "B".
6.
Attach the rear suspension
arms to the suspension brackets,
Fasten with the washers and hair pins. See illustrations "C" and
==D _.
7.
Attach the extension
spring to the blade control rod. See
illustration "E".
8.
Move the attachment
clutch to the ENGAGE position. Make
sure the mower drive belt is inside all the belt guides and is
also below the spacer tube.
9.
Make sure the mower housing is level. See the instructions on
"How To Level The Mower Housing",
10. Check the operation of the attachment
clutch. See the instruc-
tions on "How To Adjust The Attachment Clutch".
Adjuster
Arm
D'
Lifter
Assembly
Adjuster
Arm
Mower
Drive Belt
Lift Lever
Attachment
Clutch
3acer Tube
Suspension
Link
B
Hanger Rod
Front Hanger
Suspension
Link
Extension
Spring
Figure 30
F-050607L
30
Publicidad
Tabla de contenido
