Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION OF THE ADAPTATION KIT (FA 60 022 03/FA 60 022 04) FOR FALL-ARREST SYSTEM WITH
BUILT-IN RESCUE WINCH (FA 20 401 20/FA 20 401 30) ON MULTISAFEWAY (FA 60 022 00)
Once the MultiSafeWay has been installed,
1)
Place the adaptation plate (ref. FA 60 022 04, for 20 m/ref. FA 60 022 03, for 30 m) on the body of the jib where the 2 holes for this purpose
are located:
2)
Attach it using 2 ball indexing pins that slide into the adjustment holes on the jib body (Fig. 1).
The black screw should be in the lower part of the plate.
Fig. 1
INSTALLATION OF THE RETRACTABLE FALL ARRESTER WITH INTEGRATED RESCUE WINCH (FA 20 401 20/FA 20 401
30)
1)
Unscrew the black screw from the plate.
2)
Take the retractable fall arrester (FA 20 401 20 / FA 20 401 30) and put it upside down (the wire rope exit should be towards the top).
3)
Slide the metal part of the axis of the fall arrester in the gap of the plate (Fig. 2).
4)
Put the black screw in the anchor ring of the fall arrester and screw it back (Fig. 3).
Fig. 2
5)
Before use, make sure that the device is in Fall arrest mode (see point 1 of the « Use in Fall arrest mode » section).
6)
Remove the safety pin and lift the cover, unroll the cable up to the return pulley located on the jib arm and pass the cable through the pulley.
Continue to unroll the cable until it reaches the end pulley. Lift the cover and carefully thread the cable through the end pulley. Close the cover
and insert the safety pin (Fig. 5).
5
GB
Fig. 3
Publicidad
