For Best Results - Cooper Lighting RFM189 Instrucciones

RFM189_W 825-0149.qxd:Layout 1
residential installation. This equipment generates, uses and can radiate radio
frequency energy and if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

For best results

• Install the motion sensor 6-8 feet above ground
(motion sensor is less sensitive above 8 feet).
• Locate motion sensor so motion moves across detection
zone (Fig. 1).
• Locate sensor away from heat producing sources to
prevent false triggering. Also, be very careful not to include objects such as
windows, white walls and water in the detection zone whenever possible.
• Locate sensor away from moving objects such as street traffic.
Mounting your motion sensor (transmitter)
Step 1: Using both thumbs, press down and back on the
battery door located on the bottom of the sensor
head. Insert (4) AA alkaline batteries making sure
to observe proper polarity orientation located on
back of sensor head (Fig. 2). Once batteries are in
place use both thumbs to gently press down and
slide battery door back into place. Allow 60 seconds after
batteries are installed before testing (see "How to operate your fixture"
for testing instructions).
Step 2: Locate motion sensor 6-8 feet above ground and
use screws included to attach the sensor to a flat
solid surface (Fig. 3). Your sensor can be wall or
ceiling mounted. You will need to rotate head
from side to side to allow space to get to screws,
as you insert and tighten each screw in the
sensor mounting plate.
Step 3: Aim sensor head (see Step 4 and 5 under "How to operate
your fixture").
Indoor alarm/lamp control module (receiver)
Your indoor alarm/lamp control module is ready to plug in and use. There is no
installation required. This module sounds a warning chime and can turn on any
indoor lamp up to 300 watts that is plugged into the module.
Call for customer service and/or missing or damaged parts (800-334-6871)
6/5/08 3:26 PM Page 3
3
Fig. 1
Fig. 2
Fig. 3