Installing Batteries - SunTech RP-DS800 Manual Del Usuario

INSTALLING BATTERIES

Remove the battery compartment cover and install 3 x AA
alkaline batteries into the battery compartment, observing
the battery polarity diagram on the back of the radio.
Display screen would show battery capacity, time, etc.
Note: If the radio is not able to be turned on. Please check
if the batteries were installed correctly, battery capacity is
sufficient or the lock function had been applied with symbol
" " displayed on screen.
TUNE INTO STATIONS
Short press [POWER] button to turn on your radio, then
select your desired band by short pressing the [FM], [MW/
LW], SW [
broadcasting, fully extend the telescopic antenna for a better
reception.
Now, you can turn into your favorite station with any of the
below tuning methods:
Method 1: ETM (Easy Tuning Mode)
The ETM function allows you to tune into stations easily
and temporally store them into the ETM storage; 100
stations for FM/MW/LW & 250 stations for SW.
Note: Scanned stations will not be stored in the regular
550 memories, but will remain in the ETM temporary
storage until next ETM scanning within each band.
HOW TO USE ETM
1. Turn on the radio and select your desired band by
pressing either the FM, MW/LW or SW [
button.
2. Short press the [ETM] button with [ETM] shows on the
display to enter Easy Tuning Mode.
] or [ ] button. In case of receiving FM/SW
RP-DS800 ENGLISH MANUAL
] or [ ]
7