D-Link DFL-2560 Guia De Instalacion página 4

LCD Keypad Controls After Boot-up
Next Button
Back Button
Figure 5. Button Definitions (After Boot-up)
Once the DFL-2560/2560G has completed its
system startup routine, the LCD panel will be
ready to display the device status information.
You can use the keypad to select a desired
display option. The following table lists the
status information that can be displayed on the
firewall's LCD panel.
Item Description
Model Name: Device model name
System Status: System function status
CPU Load: CPU utilization and concurrent
Connections: sessions
Total BPS: Concurrent traffic per second
Total PPS: Concurrent packets per second
Date: Current device date
Time: Current device time
Uptime: The amount of time since last
restart
Mem: System memory utilization
IDS Sigs: IDS signature information
Interface Name: IP address for each interface
(See Table 4.)
Core Version: Current firmware version
CPU Temp. CPU and system temperature via
System Temp. on board sensor
Fan Status Fan speed
Table 4. Device Status Shown on LCD Panel
4  D-Link NetDefend Firewall
Installing and Connection
This chapter describes how to install a
DFL-2560/DFL-2560G device in a standard
19-inch equipment rack and how to connect
network and power cables to the device.
Before You Begin
Observe the following precautions to help
prevent faults, equipment failures and injuries:
- Before installation, always disconnect the
power supply.
- Ensure that the room in which you operate
the device has adequate air circulation and
that the room temperature does not exceed
40˚C (104˚F).
- Allow 1 meter (3 feet) of clear space from the
front and back of the device.
- Do not place the device in an equipment rack
frame that blocks the air vents on the sides of
the chassis. Ensure that enclosed racks have
fans and vented sides.
- Correct any of the following hazardous
conditions before any installation: moist or
wet floors, leaks, ungrounded/frayed power
cables, or missing safety grounds.
Installing Equipment
You can mount the DFL-2560/DFL-2560G
device into a standard 19-inch equipment rack.
To install an DFL-2560/DFL-2560G device into
a rack:
1. Attach the mounting brackets to each side
of the chassis as shown in figure 6 and
secure them with the provided screws.
Figure 6. Attaching Rack Mount Brackets