Black and Decker CM1836 Manual De Instrucciones página 9

CHARGING PROCEDURE- FIGURES F & G
1. Remove safety key F-1.
2. Align the charger plug F-2 with the arrow F-4 on top and insert the charger plug into the receptacle F-3 on the mower (green terminal to
green terminal, white terminal to white terminal). The charger connector can only be plugged into the mower receptacle one way.
3. Insert the 120 volt plug G-3 of the charger G-1 into the wall receptacle.
4. The red light G-2 on the charger should come on indicating you have power and the battery is being charged. Check the charger for the red
light, if it is not on check the charger connector for proper alignment (step 2). The red light should extinguish and the green light will come on
when charging is complete (takes approximately 12 - 20 hours to charge a fully discharged mower).
5. It is recommended to leave the battery on constant charge (between mowing uses) for optimum performance during the mowing season.
6. The charger supplied with this product is intended to be plugged in such that it is correctly orientated in a vertical or floor mount position.
F
OPERATION
KNOW YOUR MOWER
READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR MOWER. See "Functional Description" - to
familiarize yourself with the location of various controls and adjustments. Save this manual for future reference.
SAFETY KEY
SHARP MOVING BLADE.
DANGER :
In order to prevent accidental start-up or unauthorized use of your Cordless Mower, a removable Safety Key has been incorporated into the
design of your mower. The mower will be completely disabled when the Safety Key has been removed from the mower. With the Safety Key
removed, you will have access to the charger receptacle.
NOTE: THE SAFETY KEY HAS A SLOT TO ALLOW FOR STORAGE ON A NAIL, OUT OF THE REACH OF CHILDREN. DO NOT TETHER
SAFETY KEY TO MOWER.
DANGER:
ROTATING BLADES CAN CAUSE SERIOUS INJURY. TO PREVENT SERIOUS INJURY, REMOVE SAFETY KEY WHEN
UNATTENDED, OR WHEN CHARGING, CLEANING, SERVICING, TRANSPORTING, LIFTING, OR STORING MOWER.
TO TURN MOWER ON
Insert safety key F-1 into the switch housing, until it is fully seated inside housing. The mower is now operational and can be started by
activating the switch lever H-2.
DANGER:
SHARP MOVING BLADE. NEVER ATTEMPT TO OVERRIDE THE OPERATION OF THIS SWITCH AND SAFETY KEY
SYSTEM AS SERIOUS INJURY COULD RESULT.
G
9