Infrared Thermometer / Thermomètre infrarouge
FUNCTION
Press Mode key () for scrolling more display function as follows.
Here will show the emissivity data. (The default emissivity is 0.95.)
Press Mode key () , then press Lock key () or
set the emissivity, then press Mode key () to confirm it. The
emissivity can be changed from 0.10 (10E) to 1 (100E).
Press Mode key () for the Maximum (MAX), Minimum (MIN),
Different between MAX and MIN (DIF) and Average (AVG) modes.
During the measurement, the special modes reading will be
displayed beside the mode icon.
Press Lock key ()or
(HAL) or Lo Alarm (LAL), then press Meas. key () to confirm it.
When the reading is outside the High Alarm (HAL) or Lo Alarm (LAL)
limit. You will hear a beep sound.
ADD VALUE
In E,MAX, MIN, DIF, AVG mode:
In all modes: First hold on
the Meas. key ()
Memory
CAUTION
1. When device is in use, do not look directly into the laser beam–permanent eye damage may result.
2. Use extreme caution when operating the laser.
3. Never point the device towards anyone's eyes.
4. Keep out of reach of all children.
STORAGE & CLEANING
- It should be stored at room temperature. The sensor lens is the most delicate part of the thermometer. The lens
should be kept clean at all times, care should be taken when cleaning the lens using only a soft cloth or cotton swab
with water or medical alcohol, allowing the lens to fully dry before using the thermometer. Do not submerge any part
of the thermometer.
- LCD ERROR MESSAGES
The thermometer incorporates visual diagnostic messages as follows:
C/
F key () to change the High Alarm
º
º
Press Lock key () for LOCK mode ON/OFF. The lock mode is particularly
useful for continuous monitoring of temperatures for up to 60 minutes.
Press
C/
F key () for
C or
o
o
o
and press Lock key () for backlight function ON/OFF
and press
C/
F key () for laser function ON/OFF.
o
o
Recall the last reading memory by pressing Mode key () while power off.
2
RTMT-12001
C/
F key () to
o
o
F transferred.
o
User manual