Battery Replacement - Rosewill RTMT-12001 Manual Del Usurio

Infrared Thermometer / Thermomètre infrarouge
'Er2' is displayed when the thermometer is exposed to rapid changes in
the ambient temperature. 'Er3' is displayed when the ambient
temperature exceeds 0
should be allowed plenty of time (minimum 30 minutes) to stabilize to
the working/room temperature.
Error 5~9, for all other error messages it is necessary to reset the
thermometer. To reset it, turn the instrument off, remove the battery
and wait for a minimum of one minute, reinsert the battery and turn on.
If the error message remains please contact the Service Department
for further assistance.
BATTERIES
The thermometer incorporates visual low battery indication as follows:
'Battery OK':
measurements are possible

BATTERY REPLACEMENT

1. Pull out the rubber gasket ()
2. Loosen the screw and pull out the battery cover
3. Replace and reinstall with new batteries
4. Place the battery cover back and fasten the screw
5. Plug the rubber gasket () to avoid failure of water proof
When the 'Low Battery' icon indicates the battery is low, the battery should be
replaced immediately with AAA, 1.5V batteries. Please note: It is important to turn
the instrument off before replacing the battery otherwise the thermometer may
malfunction.
Dispose of used battery promptly and keep away from children.
C (32°F) or +50
o
'Battery Low': battery needs to be
replaced, measurements are still possible
3
RTMT-12001
C (122°F). The thermometer
o
'Battery Exhausted': measurements
are not possible
User manual