NOTE
If you have a dryer and dryer:
•
To set the dryer to the same height as
the washer, fully retract (A) the leveling
feet by turning
them counterclockwise,
then loosen (B) the feet by turning
them clockwise. Once the dryer is the
same height as the washer, follow the
directions
above to level the dryer.
•
Adjust the leveling feet only as much as
necessary to level the dryer. Extending
the leveling feet more than necessary
can cause the dryer to vibrate.
10. Make sure all gas connections (on gas models) and exhaust, and electrical connections
are
complete.
Plug in your dryer, and then check its operation
by using the checklist on page 28.
11. For GAS MODELS ONLY: The burner may not ignite initially
due to air in the gas line.
Allowing
your dryer to operate on a heat setting will purge the line. If the gas does not
ignite within 5 minutes, turn your dryer off and wait 5 minutes. Be sure the gas supply to
your dryer has been turned on. To confirm
gas ignition, check the exhaust for heat.
English
25