auna Intelligence Amp Manual Del Usuario página 23

BT connection setup
1. Switch the system ON and make sure that the device is in BT mode.
You can switch to BT mode by pressing the MODE button until the BT
indicator light starts flashing continuously, indicating that the amplifier
is ready to pair with your smartphone. When you turn on or pair the unit,
you can hear the voice prompts „Power ON" and „Pairing".
2. Make sure your BT-enabled smartphone is turned on and VT is enabled.
Select „BT-RY" from the BT list and connect the smartphone to the
amplifier.
3. After successful pairing you will hear the voice announcement: „Your
device is connected" and the BT indicator light will stop flashing.
Note: If your device does not establish a connection, press and hold the
BT button and try pairing again.
AUX input (3.5 mm) for audio playback
If you turn on the amplifier and an external device is connected to the
amplifier via an AUX cable, the music playing on the external device will
be played automatically. BT or WiFi streaming is not possible during AUX
connection.
Note: If you want to play audio via BT or WiFi, disconnect the AUX
connection.
EN
23