Operating The Chain Saw; Connecting The Battery - BLACK&DECKER LCS120 Manual De Instrucciones

Chain oiling
• A high quality bar and chain oil or
SAE30 weight motor oil should be
used for chain and bar lubrication.
The use of a vegetable based bar and
chain oil is recommended when pruning
trees. Mineral oil is not recommended
because it may harm trees. Never use
waste oil or very thick oil. These may
damage your chain saw.
• Lubricate the whole chain evenly before each use as shown
in figure J. Also lubricate the chain whenever replacing a fully
discharged battery with a fully charged one.
transporting saw
• Always remove the battery (4) from
the tool (figure K) and cover the
guide bar (6) with the scabbard
(10) (figure l) when transporting
the saw. See the warning under
"Battery Cap Information"
for additional information on
transporting the battery.

oPeratinG the Chain saw

warninG: read and understand all instructions. Failure to
follow all instructions listed below may result in electric shock, fire
and/or serious personal injury.
• Guard Against Kickback which can result in severe injury
or death. See important safety instructions "guard Against
Kickback", to avoid the risk of kickback.
j
K
L
• Do not overreach. Do not cut above chest height. Make sure
your footing is firm. Keep feet apart. Divide your weight evenly on
both feet.
• Use a firm grip with your left hand on the front handle (15) and
your right hand on the rear handle (14) so that your body is to the
left of the guide bar.
• Do not hold chain saw by front hand guard (3). Keep elbow of
left arm locked so that left arm is straight to withstand a kickback.
WARNING: Never use a cross-handed grip (left hand on the
rear handle and right hand on the front handle).
WARNING: Never allow any part of your body to be in line with
the guide bar (6) when operating the chain saw.
• Never operate while in a tree, in any awkward position or on
a ladder or other unstable surface. You may lose control of saw
causing severe injury.
• Keep the chain saw running at full speed the entire time you
are cutting.
• allow the chain to cut for you. Exert only light pressure. Do not
put pressure on chain saw at end of cut.

Connecting the Battery

• Place the battery (4) into the tool as
shown in figure m and be certain that it
is inserted fully into the tool cavity until it
"clicks" into place. To remove the battery
from the tool, press down on the release
button (21) on the back of the battery and
slide out.
switch
• Always be sure of your footing and
grip the chain saw firmly with both
hands with the thumb and fingers
encircling both handles.
• To turn the tool ON push the lock
off button (2) to either side and
squeeze the trigger switch (1) with
12 12
M
21
N
2
1