Cool Mode; Air Direction - GE AEC08 Manual Del Usuario

Controls

Cool Mode

Use the Cool mode at Low, Med, High or Auto Fan
Speed for cooling. Use the Temperature Increase + /
Decrease - pads to set the desired temperature between
64°F and 86°F in 1°F increments.
An electronic thermostat is used to maintain the room
temperature. The compressor will cycle on and off
to keep the room at the set level of comfort. Set the
thermostat at a lower number and the indoor air will
become cooler. Set the thermostat at a higher number
and the indoor air will become warmer.
ECO Mode
This mode optimizes the cooling power of your air
conditioner, thereby saving you energy. Once the set
point temperature has been reached, the fan will cycle
off to save energy. The fan will cycle back on periodically
to insure all cooling capacity in the system is used. This
mode is the default mode for the unit. Each time the unit
is powered off, it will restart in ECO mode ON. The first
time the unit is turned on, the settings will be 70° and
Low fan. You can adjust the fan speed and temperature
to your personal comfort.
Fan Only Mode
Use the Fan Only Mode at Low, Med or High fan speed
to provide air circulation and filtering without cooling.
Since fan-only settings do not provide cooling, a Set
temperature cannot be entered. The room temperature
will appear in the display.
Auto Fan Speed
Set to Auto fan speed for the fan speed to automatically
set to the speed needed to provide optimum comfort
settings with the set temperature.
Power Outage Recovery Feature
In the case of a power outage or interruption, the unit will
automatically restart in the settings last used after the
power is restored.

Air Direction

Use the lever to adjust the air direction left and right
only.
6
NOTE: If the air conditioner is off and is then turned on
while set to a Cool setting or if turned from a fan setting
to a Cool setting, it may take approximately 3 minutes for
the compressor to start and cooling to begin.
Cooling Descriptions
For Normal Cooling—Select the Cool mode and High
or Med fan with a middle set temperature.
For Maximum Cooling—Select the Cool mode and
High fan with a lower set temperature.
For Quieter and Nighttime Cooling—Select the Cool
mode and Low fan with a middle set temperature.
ECO ON—Helps minimize electricity use. It is normal
for the fan to cycle off and then back on in this mode.
This on/off cycle can repeat multiple times. Because
the fan will cycle off, you may notice a variation in room
temperature and humidity.
ECO OFF—When this mode is not engaged, the fan will
run continuously, and in Cool mode the compressor will
cycle on and off to maintain room temperature.
NOTE: Auto Fan Speed cannot be used when in the Fan
Only Mode.
If the room needs more cooling, the fan speed will
automatically increase. If the room needs less cooling,
the fan speed will automatically decrease.
NOTE: Auto Fan Speed cannot be used when in the Fan
Only Mode.
49-7805-3