Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
[] FAQ
My remote control does not work. What
should I do?
• Check the antenna
or cable connection
to the main unit.
• Check the batteries
of the remote control.
• Check if there is an obstacle
between
the infrared sensor window
and
the remote control.
• Test the signal output.
If OK, then possible infrared sensor trouble.
(Refer to'lR
Signal Check" on page 33.)
• Aim the remote control
directly
at the infrared sensor window
on the
front of the unit.
• Reduce the distance to the unit.
• Re-insert the batteries with their polarities
(+/- signs) as indicated.
• When there is an infrared-equipped
device such as PC near this unit, it
may interrupt
the remote control
signal of this unit.
• Move the infrared-equipped
device away from this unit, change the
angle of the infrared sensor or turn off the infrared
communication
function.
HOW come the Initial setup appears every
! connect
the RF cable to the unit directly
and run the initial setup.
time I turn on this unit?
, Make sure to complete
the channel
scan before turning
offthe
unit.
• Make sure auto channel
scan has been completed.
(Refer to "Auto Channel Scan" on page 13.)
• Auto channel
scan must be completed
when you set up the unit for the
first time or move it to a location
where previously
unavailable
channels
are broadcast.
• The selected channel
may not be broadcasting.
• When auto channel
scan is interrupted
and not completed,
Why I cannot watch some of TV programs?
some channels will not be received. Make sure to complete.
(Refer to "Auto Channel Scan" on page 13.)
• The selected channel
cannot be viewed
by the V-chip setting.
(Refer to "V-chip" on page 27.)
• The unit requires some kind of antenna
input. An indoor antenna
(rabbit
ears), an external
antenna,
or an RF coaxial cable from your wall or cable
/satellite
box needs to be plugged
into the unit.
....
right input mode iSselected by pressing
[INPUT SELECT] 0[
How come there is no image from the
.....
i Check if the
using
[CH A /V
]. (Refer to"Switching
Each Input
Mode" on page16.)
connected external
devices?
, Check the antenna
or cable connection to the unit.
• Many digital
channels have alternate
channel numbers.The
unit changes
Whenever
I entered
channel number,
the numbers
automatically
to the ones signifying
the broadcasting
it changes automatically,
stations. These are the numbers
used for analog broadcasts.
i Captions that are delayed a few seconds behind the actua! dialogue
are
Why are Captions not displayed
enti[ely?
common for live broadcasts.
Most captioning production
companies
can
Or, captions are de!ayed behind the
display
a dialogue
to maximum
of 220 words per minute. If a dialogue
dialogue,
exceeds that rate, selective editing
is used to insure that the captions
remain up-to date with the current TV screen dialogue.
How can I set the clock ?
• There is no clock function
on this unit.
EN
Publicidad
Tabla de contenido
