Emerson LC320EM9 B Manual De Instrucciones página 4

[] Attaching the Stand
You must attach the stand to the unit to display upright. Be sure the front and rear of the stand match the proper direction.
1
Spread a thick and soft cloth over a
table.
Place the main unit face down onto it.
Make sure not to damage the screen.
At least two people are required at
this _p.
2 Insert the stand all the way to the
main unit slowly until it clicks.
Make sure not to put the AC cord
between the stand and the unit.
3 Drive Phillips pan screws in the 3
threaded holes at the bottom of the
stand with a screwdriver tightly.
To Remove the Stand from this Unit
Unscrew the Phillips pan screws indicated by"(1}", then lift the lever on the bottom
stand and remove the stand from the unit slowly. Be careful not to drop the stand
when you remove it.
lever_
Note:
• When attaching the stand, ensure that all screws are tightly fastened. If the stand is not properly attached, it could cause the unit to fall,
resulting in injuries as well asdamage to the unit.
•Make sure to use a table which can support the weight of this unit and is larger than this unit.
•Make sure the table is in a stable location.
[] Symbols Used in this Manual
The following is the description for the symbols used in this manual.
Description refers to:
: Digital TV operation : Analog TV operation
• If neither symbol appears under the function heading, operation is applicable to both.
[] Trademark Information
• HDMI, the HDMI logo and High-Definition Multimedia Interface are trademarks or registered trademarks of HDMI
Licensing LLC.
• Manufactured under license from Dolby Laboratories."Dolby"and the double-D symbol are trademarks of Dolby
Laboratories.
• Products that have earned ENERGY STAR®are designed to protect the environment through superior energy efficiency.
EN