EqUIPMENT'S OPERATION
cleaning methods
5. When cleaning is complete, remove the basket and objects. If there are many objects
and some debris remaining, add 5 minutes and repeat the cleaning.
6. Replace the water and wash the objects for more 3 minutes to remove the remaining
chemical waste.
During cleaning the debris separate from the objects as "smoke". The water
becomes blurred. This method will remove the rust and will cause objects to
appear as new.
Operating guidelines
Remove the lid, place the items in the basket, and then
put them in the cleaning tank. Add water until a level
between MIN and MAX and above the objects.
If the device is switched on without water, the
ultrasonic energy will not be absorbed. After more
than 30 seconds, this procedure can damage the
device or drastically reduce its lifetime.
Connect the power cord into a power outlet.
The LED display shows
is the most common for the clock and operating
status.
If the clock needs to be adjusted, press the SET
buttons and
(as required).
The clock can be set between 1 and 30 minutes.
The periods of common cleaning are 5, 10 and 15
minutes.
The extension of the cleaning period can result in:
a. Loosening the screws (if used).
b. Increased preexisting cracks.
c. Peeling on the lining of the object.
. This configuration
17