Display; Temperature Setting - Kenmore 580.75121 Manual Del Propietário

DISPLAY
• Every time you push this button, it advances the setting as follows: {High _Low _Med _High}
_ REMOTE CONTROL SIGNAL
coo•
RECEIVER
, TEMPERATURE SETTING
F_ e • This button can automatically control the
_'i_: • :TE_R temperature of the room
The temperature can be set within a range
of 60°F to 86°F by increments of I°F
(-TIMER
SHUT-OFF TIME
• You will usually use shut-off time while you sleep
• If unit is running, Timer sets number of hours until shut-off
• Every time you push Timer button, it advances the Timer setting
as follows: 1 Hour * 2 Hours ...... 12 Hoursmaximum.
- START TIME
• If unit is off, Timer sets number of hours before unit starts.
POWER
• To turn the air conditioner ON, push the
button
To turn the air conditioner OFF, push
the button again
• This button takes priority over any other
button
• When you first turn it on, the air conditioner is
on the High cool mode and the Temp at 72°F
• Every time you push Timer button, it advances the Timer setting as follows: 1 Hour _2 Hours ....... 12 Hours
maximum
MODE
- Every time you push this button, it will shift among COOL, ENERGY SAVER and FAN
- ENERGY SAVER:
• The fan stops when the compressor stops cooling
Approximately every 3 minutes the fan will turn on and check the room air to determine if cooling is
needed
Elll_oJ:/_'Jf__f:_ "
In failure of electric power, the unit runs as previous setting operation. J
]
HORIZONTAL AIR DIRECTION CONTROL VERTICAL AIR DIRECTION CONTROL
The horizontalair directionis adjustedby moving the vertical The vertical air direction is adjustedby movingthe horizontal
louvers right and left with yourfingertips. (FIG.26) louvers up anddown withyour fingertips. (FIG.27)
/
FIG. 26 FIG. 27
-11 -