Using Your TV or Cable/Satellite Remote (IR only)
to Control the MagniFi Mini
The MagniFi Mini works best with the included remote, however you
can also teach it to respond to your favorite TV or cable IR remote
by following these steps:
IMPORTANT: Hold both remotes about 12" (30cm) directly in front of the MagniFi Mini
when pressing their respective buttons, make sure you wait at least 1 second between
button presses, make sure your remotes have fresh batteries
1. Enter learn mode by pressing and holding the
button on the sound bar until you hear a tone and the lights
on the front of the sound bar pulse up and down.
2. Press and release the button on the MagniFi Mini remote that
you want to learn (ex: Volume Up).
3. Press and Release the corresponding button on YOUR
remote repeatedly until you hear a two note ascending tone.
NOTE: Make sure you wait at least 1 second between button presses!
4. Repeat steps 2 and 3 to learn Volume Down, Mute, and Power buttons from your
remote.
5. Exit learn mode by pressing and holding the
bar again until you hear a tone and the lights on the front of the sound bar stop
pulsing.
6. Verify that your remote can control the buttons you programmed (ex: Volume up)
on the MagniFi Mini.
NOTE:
•You will hear a different (descending) tone if the command failed to learn. Please try again.
•MagniFi Mini will exit Learn mode after 1 minute of in activity, saving any learned codes
Source
Source button on the sound
12" (30cm)