Descargar Imprimir esta página
Guinaz M1934 Guia De Instalacion
Guinaz M1934 Guia De Instalacion

Guinaz M1934 Guia De Instalacion

Distribuidor de video para coaxial

Publicidad

Enlaces rápidos

CONFIGURACIÓN ESPECIAL PARA LARGAS DISTANCIAS.
SPECIAL CONFIGURATION FOR LONG DISTANCES.
It is recommended the power supply ground cable of
the installation (cable n° 5 in the case of standard
monitors or cable 2M in that of digital monitors) is
connected to terminal block 2/5 (GROUND) of the
distributor in installations in which the distance between
the street panel and the distributor exceeds 500 metres.
Apart from this connection, it is necessary to modify
the internal configuration of the distributor. Open the
distributor and change the internal configuration bridge
to position J2 (default position is J1) to do so. The
diagram of FIGURE 3 shows an example of this:
M1725V2
Do no shut-off the resistance
meters
M1934
POWER SUPPLY CABLE
COAXIAL CABLE (75 ohm)
FIGURE 3. Diagram for connection and configuration of a video distributor for long distances. Example using digital
colour monitors ref. M1725V2.
M1725V2
Connect to 2M wire of the digital BUS
Internal configuration bridge

Publicidad

loading

Resumen de contenidos para Guinaz M1934

  • Página 1 FIGURE 3 shows an example of this: M1725V2 M1725V2 Do no shut-off the resistance meters M1934 Connect to 2M wire of the digital BUS Internal configuration bridge POWER SUPPLY CABLE COAXIAL CABLE (75 ohm) FIGURE 3. Diagram for connection and configuration of a video distributor for long distances. Example using digital...
  • Página 2 FIGURE 2. Example of video signal distribution with coaxial cable, in an installation with colour monitors ref. M1720D. • • This video distributor is for exclusive use in GUINAZ video entryphone installations. It will be The distributor comes with a 75 W resistance (R installed as specified in this guide, applying 75 W, FIGURE 1) from the factory as the end of the enforced regulation.