Inmarsat Explorer 527 Manual Del Usario página 5

Switch on the EXPLORER
5
Push the power button in the left side of the front panel to switch on the
EXPLORER 527.
The display and the green power indicator in the front panel light up when
the EXPLORER 527 is on.
Enter the PIN
6
a. When you are asked for a PIN, press OK.
b. Press  or  a number of times until the
first digit is correct.
c. Press OK to go to the next digit.
The previous digit is indicated by a *.
d. After pressing OK to enter the last digit, press OK again to apply the PIN.
Connect to the BGAN network
7
When you have connected the antenna to the transceiver and started up
the EXPLORER 527, the antenna starts searching for a BGAN satellite signal.
When the PIN is entered, the EXPLORER 527 attempts to register on the
BGAN network.
The Antenna indicator shows the status as follows:
• Flashing green: The antenna is searching for the satellite signal.
• Steady green: The antenna is registered on the BGAN network and is ready
for use.
• Red: Antenna error.
The display shows the progress as follows:
• SEARCHING: The EXPLORER 527 searches for the network operator.
Note that the search procedure can be very short, so you may not see
this text.
• REGISTERING: When the network operator is found, the display shows
REGISTERING to show that the EXPLORER 527 is registering itself on the
network.
• READY: The EXPLORER 527 is registered on the network.
527
®
GB