Inmarsat Explorer 527 Manual Del Usario página 6

The display may show a different text, for example if an error has occurred.
For further information, refer to the User Manual.
By default, the EXPLORER 527 automatically searches for the satellite with
the best signal. However, you can select a specific satellite to use when
connecting to the BGAN network. Do as follows:
a. Enter the display menu system and select SETTINGS > SATELLITE.
b. Select the satellite you want to use.
Note that if you select a specific satellite the EXPLORER 527 will only
search for the selected satellite. If you are outside coverage of that
satellite, the EXPLORER 527 will not be able to register on the BGAN
network.
When the EXPLORER 527 is registered on the BGAN network the Antenna
indicator on the front panel of the EXPLORER 527 transceiver shows steady
green light.
NOTE: When the display shows READY, the EXPLORER 527 automatically
activates the LAN interface if the cable is connected and the interface is
enabled. If you are not going to use the LAN connection, remove the cable
or disable the LAN interface to avoid being charged for any transmission
through this interface.
You are now ready to make phone or fax calls, browse the Internet or check
your e-mails, send files, run a video conference and much more.
MAKING A CALL FROM THE EXPLORER
To make a call from a phone connected to the EXPLORER 527, dial
00 <country code> <phone number> #.
Example: To call Thrane & Thrane in Denmark: (+45 39558800), dial
00 45 39558800 #.
NOTE: There are two audio qualities: Standard voice and 3.1 kHz Audio.
To force the call to use Standard voice, dial 1* before the number.
To force the call to use 3.1 kHz Audio, dial 2* before the number.
527
®