Hitachi BCM241T08 Instrucciones De Seguridad Importantes página 10

1.3 Display Unit Setup
Using Internal Battery
1. The display unit uses an internal, rechargeable battery (3.7V
1100mAh Li-ion) or it can use the provided AC power adapter. For
first time use, please allow the battery to fully charge (approximately
4 hours) before using it without the AC adapter.
2. Press the POWER button
Note: The Display Unit battery pack is not user-replaceable.
Using AC Power (See Fig. 6)
1. Plug one end of the provided power adapter into a wall outlet.
2. Connect the power adapter to the power adapter jack located on the
left side of the display.
Note 1: When the display is powered on the "Power" LED will light
Note 2: Press and hold the POWER button for approximately 3
10
up (green).
seconds to turn off the display.
to turn on the display unit. See Fig. 5.
F ig . 5
1
Fi