Assigning A Second Effect Module; More Assignments; Toggling Effects; Storing Assignments - Kemper PROFILER REMOTE Inicio Rápido

12 REMOTE QUICK START

ASSIGNING A SECOND EFFECT MODULE

To add a second assignment to the same Effect Button, just repeat the process with another effect module. You
will notice the right LEDs by the Effect Button indicate both the effect category and on/off state of your second
assignment. Now, you can activate or bypass both effects by stepping on the button on your PROFILER Remote.

MORE ASSIGNMENTS

Even more effect modules can be assigned to the same Effect Button this way. However, the LEDs will only show the
first two assignments.

TOGGLING EFFECTS

The Effect Buttons toggle the on/off states of each of their assigned effect modules independently, depending on
their current state. So, not only can you activate (or bypass) multiple effects simultaneously - you can also activate
some effect modules while bypassing others. The white LEDs will reflect this accordingly.
Example: Currently, effect module D is activated, and module X is bypassed. Both effect modules are assigned to
the same Effect Button. If you hit this Effect Button, module D will be bypassed, and module X will be activated. This
allows you to toggle between different effect scenes.

STORING ASSIGNMENTS

Once you are happy with the assignments and the current on/off states, then simply store the Rig. All assignments
that you have created are stored with the individual Rig. Whenever you load this Rig later, the assignments and the
on/off states are recalled just as they were when you stored the Rig.