Assignments Without Remote; Keeping Oversight; Action & Freeze; Latched / Momentary - Kemper PROFILER REMOTE Inicio Rápido

REMOTE QUICK START 13

ASSIGNMENTS WITHOUT REMOTE

If your PROFILER Remote is not connected, or if your stage is so huge that your PROFILER is miles away from the
Remote, you will not be able to reach both at the same time. In this case, enter the Remote Effect Buttons page
in Rig Settings, hold one of the four soft buttons, and press one or more effect module buttons to complete the
assignment.

KEEPING OVERSIGHT

To help you maintain an overview, a list of your current assignments will be displayed on the Remote Effect Buttons
page in Rig Settings. You can also immediately clear assignments on this page.
ACTION & FREEZE
Besides toggling the status of effect modules, each of the Effect Buttons can also be used to trigger so-called
"Action & Freeze" functions like "Rotary Speaker (slow/fast)", "Delay Feedback Infinity", or the Freeze function of
most delay and reverb effects. To assign, simply navigate to the respective function within the effect e. g. "Rotary
Speed Slow/Fast" within the Rotary Speaker effect. Now press the respective soft button above the display of
the PROFILER together with one of the Remote's Effect Buttons. Done! Don't forget to store the Rig to make your
assignment permanent.

LATCHED / MOMENTARY

Every Effect Button on the PROFILER Remote supports an automatic latched / momentary detection: A quick press
of the button will latch the assigned function - in other words, the assigned effect modules will change their on/off
state permanently, until you press the button again.
However, if you hold the Effect Button for a second or more, it will automatically change to momentary operation.
Momentary operation means that as soon as you release this Effect Button, it will immediately revert to the initial
state. This behavior applies to on/off switching as well as to "Action & Freeze" functions.