Yealink SIP-T23P Manual Del Usuario página 8

E
Basic Call Features
N
G
Placing a Call
L
Using the handset:
I
1. Pick up the handset.
S
2. Enter the number, and then press the Send soft key.
H
Using the speakerphone:
1. With the handset on-hook, press
2. Enter the number, and then press the Send soft key.
Using the headset:
1. With the headset connected, press
2. Enter the number, and then press the Send soft key.
Note: During a call, you can alternate between the headset, hands-free speakerphone and handset modes by pressing the HEADSET
key, the Speakerphone key or by picking up the handset. Headset mode requires a headset connected.
Answering a Call
Using the handset:
Pick up the handset.
Using the speakerphone:
Press .
Using the headset:
Press .
Note: You can reject an incoming call by pressing the Reject soft key.
Ending a Call
Using the handset:
Hang up the handset or press the EndCall soft key.
Using the speakerphone:
Press or press the
Using the headset:
Press the EndCall soft key.
Redial
 Press to enter the Placed Calls list, press
 Press twice when the phone is idle to dial out the last dialed number.
Call Mute and Un-mute
 Press to mute the microphone during a call.
 Press again to un-mute the call.
Call Hold and Resume
To place a call on hold:
Press the Hold soft key during an active call.
To resume the call, do one of the following:
 If there is only one call on hold, press the Resume soft key.
 If there is more than one call on hold, press
4
.
to activate the headset mode.
EndCall soft key.
or
or to select the desired entry, and then press
to select the desired call, and then press the Resume soft key.
or the Send soft key.