Water Filter Status Light; Water Filtration System - Kenmore 106.58329800 Manual De Uso Y Cuidado

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

To turn off the dispenser, press the LOCK button. The indicator
will appear above the LOCK button and the ice and water
dispensers will not work. To unlock the dispenser, press the
UNLOCK button until the indicator appears. Then continue to
dispense ice or water as usual.
DISPENSER
LOCK
UNLOCK
F:i/te
tus Light
(on some nr_od<!:_l@
The water filter status light will help you know when to change
your water filter. When the status light changes from green to
yellow, this tells you that it is almost time to change the water
filter. It is recommended
that you replace the filter when the
status light changes to red OR when water flow to your water
dispenser or ice maker decreases noticeably. The filter should be
replaced at least every 6 months depending on your water quality
and usage. To change the filter, see "Water Filtration System."
INDICATOR:
STATUS:
GOOD (green)
New filter installed
ORDER (yellow)
Order filter
REPLACE (red) OR
Replace water filter
when water flow decreases
After changing the water filter, reset the status light by pressing
and holding the RESET button for 2 seconds. The status light will
change
from Replace
(red) to Good (green) when the system
is
reset.
WATER
FILTER
GOOD •
OI_DEr_ • RESET
REPb\CE•
2,
3,
4,
There will be water in the filter. Some spilling may occur.
A
.............................................................................................
A. Eject button
B. Filter cap
Remove the cap by turning it counterclockwise
until it stops.
IMPORTANT:
Do not discard the cap. It is part of your
refrigerator. Keep the cap to use with the replacement filter.
Take the new cartridge out of its packaging
and remove the
cover from O-rings.
A B ............................
C_.%
A. Cover
B. O-rings
Place the cap (removed in Step 2) on the new filter. Align the
ridge on the cap with the arrow on the filter. Turn the cap
clockwise until it snaps into place.
Do not use with water that is microbiologically
unsafe or
of unknown quality without adequate disinfection before
or after the system. Systems certified for cyst reduction
may be used on disinfected waters that may contain
filterable cysts.
Changing
the Water
Filter
The water filter is located in the base grille below the freezer
compartment
door. It is not necessary to remove the base grille
to remove the filter.
1. Remove the filter by pressing the eject button and pulling
straight out on the filter cap.
NOTES:
Avoid twisting the cap when removing the filter because
this could cause the cap to come off. If this occurs,
replace the cap and pull the filter straight out.
A. Eject button
B. Arrow on filter
C. Ridge on cap
5. Push the new filter into the opening in the base grille. As the
filter is inserted, the eject button will depress. The eject
button will pop back out when the filter is fully engaged.
6. Pull gently on the cap to check that the filter is securely in
place.
7. Flush the water system. See "Flushing the Water System
After Changing Filter."
13

Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Tabla de contenido