Cedar Ridge MD10TBU Manual De Propietario Y De Instalación página 12

1. Snap the left and right foot columns to-
gether (see Figure 11).
2. Place the column assembly in the center
of the base cut out. Fasten column as-
sembly by using two Phillips head self
taping screws (provided) (see Figure 11).
3. Place leg bracket on the top of column as-
sembly and fasten it by using two Phillips
head self tapping screws (provided) (see
Figure 11).
4. Align four screw holes to the base of
the heater and attach it by using Phillips
head self tapping screws (provided) (see
Figure 12).
Leg
Bracket
Foot
Columns
Figure 11 - Assembling Base Feet
12
INSTALLATION
INSTALLING BASE FEET
N G
L P
N G
L P
Finished
Assembly
Base Cut Out
www.usaprocom.com
5. Position the heater to the desired location.
Secure the base feet to the floor by us-
ing two Phillips head self tapping screws
(provided) (see Figure 13).
Figure 12 - Attaching Base Feet to Heater
Screw
Figure 13 - Securing Heater to Floor
Screw
Hole
Screw
200130-01C