Using The System Menu; Starting The Setup Wizard; Returning To Default Settings; Using White Wash - HP PL5060N Guia Del Usuario

Using the System Menu

Use the System menu to select the language for the
OSD menus, find the software version, start the Setup
Wizard, return OSD settings to default values, select
the Standby Mode, and start White Wash to reduce
the appearance of afterimage.
System menu
OSD
Software Version
Setup Wizard
Default Settings
White Wash
Standby Mode

Starting the Setup Wizard

In the Setup Wizard menu, choose Yes, and press
OK. Then, turn off the TV, and turn it on again to start
the Setup Wizard.
40
HP Plasma HDTV User's Guide
Options
Language: English/
■
French/Spanish
OSD timeout: Short/
■
Middle/Long
Shows TV software
version number
Start the setup wizard:
Yes/No
Press OK to recover all
settings to default
values.
Yes/No
■
Low power
■
Fast power
■

Returning to Default Settings

In the Default Settings menu, return all settings,
including the channel list, to default value by selecting
Default Settings, and then pressing OK.

Using White Wash

In the White Wash menu, select Yes and press OK to
display an all-white screen for 3 minutes. This can
reduce the appearance of an afterimage resulting from
a fixed screen image.
Extensive use of White Wash may reduce
the lifetime of the panel.
Selecting the Standby Mode
(Power Control)
The Standby Mode menu setting can save energy. The
setting determines the power used by the TV when it is
turned off and enters standby.
Low power: Consumes less power while in
■
standby, uses approximately 20 seconds of
power-up time.
Fast power: Consumes more power while in
■
standby, uses approximately 5 seconds of power-
up time.
n